2M Stainless Steel Foil Sheet 15mm x 0.3mm Thick Fine Plate Strip Steel

This 15mm × 0.3mm foil strip is commonly used as a shim, spacer, backing plate, binding strap, or decorative trim in DIY repairs, appliance work, cabinetry, HVAC ducting, and light fabrication projects. Its thin gauge makes it easy to fit into tight clearances.

Yes. At 0.3mm thick, the strip cuts cleanly with standard metal shears (tin snips), a rotary tool with a cutting disc, or a sharp utility knife scored against a metal straightedge. Always wear gloves when handling cut edges.

Stainless steel has inherent corrosion resistance due to its chromium content, which forms a passive oxide layer on the surface. This strip is suitable for humid and mildly corrosive environments. For prolonged saltwater or chemical exposure, confirm the specific alloy grade meets your application requirements.

A 0.3mm foil strip has moderate tensile strength suitable for light clamping, binding, and shimming tasks. It is not rated for structural load-bearing applications. If you need to hold significant tension or shear loads, consider a thicker gauge strip.

For shimming gaps or backing thin panels, match the strip width to the contact surface and choose a thickness equal to or slightly less than the gap you need to fill. For binding or strapping, 15mm width provides a good grip surface for most bundling tasks. If you need a different width or thickness, check our other stainless steel strip listings.

Yes. At 0.3mm thickness, the strip bends easily by hand around a rounded form or with basic sheet metal pliers. It will hold a bend without cracking under normal DIY conditions. For tight-radius bends, use a mandrel or round bar to avoid kinking.

The strip is packaged flat to minimize any set or curvature. If minor bowing occurs during transit, it can be straightened by hand or by placing it on a flat surface under light pressure for a short time.