LIFTING EYE BOLTS NUTS & WASHERS A2 STAINLESS STEEL M3 M4 M5 M6 M8 M10 M12 - M30

Match the thread diameter (M3–M30) to your tapped hole or nut size, and select a shank length that allows the nut and washer to seat fully against your material with at least 1–1.5× the bolt diameter of thread engagement. For load-bearing use, always verify the working load limit for the specific diameter against your calculated load — larger diameters (M12 and above) are suited to heavier rigging tasks.

These eye bolts are designed as lifting and rigging anchor points. However, working load limits vary by diameter and installation method. Always install the bolt fully with the nut and washer tightened against a solid bearing surface, and never exceed the rated load for the chosen size. For safety-critical overhead lifting, consult the load rating for your specific variant and follow applicable local safety standards.

A2 (304) stainless steel offers strong resistance to atmospheric corrosion, fresh water, and moderate salt-air exposure. It is widely used in marine hardware, outdoor rigging, and coastal construction. For continuous full-immersion seawater applications, A4 (316) stainless is generally preferred — but for above-waterline marine use and outdoor environments, A2 performs reliably over extended periods.

Yes. These eye bolts are machined to standard ISO metric thread specifications, so they are compatible with any metric hex nut, threaded insert, or tapped hole of the matching diameter and standard pitch. The included nut and washer are also metric-standard, so you can mix them with other metric hardware in your workshop without compatibility issues.

Each pack quantity option contains that number of complete kits — each kit includes one eye bolt, one hex nut, and one flat washer. A 2-piece pack gives you two complete sets, a 5-piece pack gives five complete sets, and so on. Choose the quantity that matches your project: single-point anchors need just 1–2 pieces, while rigging arrays or batch builds benefit from the 5 or 10-piece packs at a lower per-unit cost.

Absolutely. Smaller sizes (M3–M5) are popular among PC modders and electronics enclosure builders as cable-management anchor points, panel-mounting loops, and strain-relief anchors. The stainless finish is clean and non-reactive, and the compact loop profile keeps cable routing tidy without adding bulk. Pair with M3 or M4 threaded inserts for tool-free panel access.

Yes — the included hex nut and flat washer are matched to the same metric thread diameter as the eye bolt in each kit. For example, an M6 eye bolt ships with an M6 hex nut and an M6 flat washer. No additional sizing or sourcing is required; the kit is ready to install straight from the pack.