2MM Brushed Stainless Steel Sheet Grade 304 Guillotine Cut Plate Thick 0.02-1mm

For precision shimming (e.g., aligning machine beds or bearing housings), thicknesses of 0.02–0.10 mm are typical. For gasket blanks that need to compress slightly under bolt load, 0.10–0.30 mm is a common starting point. If you are unsure, order one sheet at your target thickness and test fit before committing to a larger pack.

Grade 304 has a tensile strength of approximately 515 MPa and a yield strength of around 205 MPa in the annealed condition. For light-duty brackets, enclosure panels, and covers at 0.5–1.0 mm thickness, it provides adequate rigidity. For load-bearing structural applications, consult an engineer to confirm suitability.

Grade 304 resists rust well in most indoor environments and light outdoor exposure. It is not recommended for continuous immersion in saltwater or chloride-rich environments — Grade 316 is better suited for those conditions. In normal workshop or domestic settings, 304 will remain corrosion-free with minimal maintenance.

Yes. Grade 304 stainless steel is routinely laser-cut and waterjet-cut. Thinner gauges (0.02–0.10 mm) are particularly well-suited to laser cutting with low power settings. For thicker sheets (0.5–1.0 mm), a fibre laser or waterjet will produce clean edges. Always confirm your machine's rated capacity for the chosen thickness before cutting.

The brushed finish is applied to the face side. The reverse side typically carries a mill finish (2B), which is smooth but not directionally brushed. If a brushed finish on both faces is required for your application, please contact us to confirm before ordering.

For prototyping or one-off projects, a single sheet is usually sufficient. If you anticipate offcuts or need spares for rework, a 2-pack provides a useful buffer. For small production runs or repeat cutting patterns, the 5- or 10-pack offers a lower per-sheet cost. Check the per-unit price across pack sizes before selecting.

Guillotine-cut sheets typically carry a length/width tolerance of ±0.5 mm and a thickness tolerance in line with EN 10088 or equivalent mill standards for the relevant gauge. For applications requiring tighter tolerances, please contact us to confirm the specific tolerance for your chosen thickness before ordering.