PVC Pipe Fitting Tee Socket ID 16-160mm T Piece Connector Adhesive Pipe Fittings

Measure the inner diameter (ID) of your existing pipe. The size listed in each variant (e.g., 25mm, 50mm) refers to the pipe's inner diameter that the socket is designed to accept. If you are unsure, measure the outer diameter of your pipe and subtract twice the wall thickness, or check the pipe's printed markings for the nominal size.

Yes. These tee sockets are compatible with standard-wall PVC pipe used in both pressure (water supply) and drainage (DWV) applications, provided the pipe outer diameter matches the socket bore. Always verify the pipe's OD against the fitting's socket ID before purchasing.

Use a PVC-rated solvent cement (also called PVC glue or PVC adhesive). Apply a thin, even coat to both the pipe end and the inside of the socket, then push the pipe firmly into the socket with a slight twisting motion. Allow at least 15–30 minutes of cure time before running water through the joint, and 24 hours before full pressure service.

A correctly made solvent-weld joint chemically fuses the pipe and fitting into a single piece, typically achieving strength equal to or greater than the pipe wall itself. The joint is resistant to pull-out, vibration, and water hammer when properly cured. Pressure ratings vary by pipe schedule and size — refer to the pipe manufacturer's data sheet for the specific rating of your system.

Yes. Rigid PVC does not rust or corrode and is unaffected by soil moisture, most fertilisers, and common household chemicals. These fittings are suitable for buried drainage runs, underground irrigation manifolds, and damp or wet above-ground environments. Ensure the solvent-weld joint is fully cured before backfilling.

Standard rigid PVC is rated for cold-water service up to approximately 60°C (140°F). It is not recommended for continuous hot-water supply lines above this temperature. For hot-water applications, consider CPVC or other heat-rated fittings. These PVC tee sockets are ideal for cold-water supply, drainage, grey-water, and irrigation systems.

No specialist tools are required. You will need a pipe cutter or hacksaw to cut the pipe to length, a deburring tool or sandpaper to smooth the cut end, PVC solvent cement, and a clean cloth to wipe the surfaces before bonding. The push-fit solvent-weld process is straightforward and well-suited to DIY installation.

Absolutely. PVC tee socket fittings are widely used in garden drip-irrigation manifolds, sprinkler branch lines, and rainwater harvesting pipe networks. Select the size that matches your irrigation pipe's inner diameter, and bond with PVC solvent cement for a permanent, leak-free branch connection.