Stainless Steel Adjustable Clip Pipe Tube Clamps Fits 8-44mm Dia Hose + Wrench

Measure the outer diameter (OD) of your hose or pipe when it is already fitted onto the fitting or barb — the hose expands slightly when pushed on. Select the size variant whose range comfortably covers that measurement. For example, if your hose OD measures 14mm when fitted, the 10–16mm variant gives you adjustment room on both sides.

Worm-drive stainless steel clamps are widely used on low-to-medium pressure lines such as automotive coolant hoses, garden irrigation, and air lines. The actual holding strength depends on correct sizing and proper tightening torque. For high-pressure hydraulic applications, consult the pressure rating of your specific hose and fitting before use.

The band and housing are stainless steel, which provides good resistance to rust and surface oxidation in outdoor, damp, and under-hood conditions. For prolonged submersion or highly corrosive chemical environments, verify compatibility with your specific exposure conditions before installation.

These clamps are compatible with rubber, silicone, PVC, and flexible plastic hoses. The worm-drive band distributes clamping force evenly around the hose circumference, reducing the risk of cutting into softer hose materials when tightened to the appropriate torque.

Yes. The worm-drive mechanism allows the clamp to be loosened, slid off, and re-tightened on the same or a different hose of the same diameter range. Inspect the band and screw for any deformation or thread wear before reuse, particularly if the clamp was tightened to maximum torque.

When your hose OD sits at the boundary of two size ranges — for example, 19mm falls in both the 16–25mm and 19–29mm variants — choose the variant whose midpoint is closest to your measurement. This gives you the most adjustment range and the most even band tension. If in doubt, the slightly larger range is generally easier to work with during installation.

Yes, a matching installation wrench is included with every pack — whether you order 5, 10, or 50 pieces. The wrench is sized to fit the screw head on these clamps for correct tightening without slipping.