Stainless Steel Hosetails,Bsp Thread Hose Tail Barb Connector 1 8-1" Female Male

A BSP Female (socket) fitting has an internal thread that screws onto a male-threaded port or stud on your pump, valve, or manifold. A BSP Male (stud) fitting has an external thread that screws into a female-threaded port. Check whether your equipment port is male or female before selecting your variant.

No. BSP (British Standard Pipe) and NPT (National Pipe Thread) are different standards with different thread angles and pitches. BSP uses a 55° thread angle; NPT uses 60°. They are not directly interchangeable. Always confirm your port thread standard before ordering.

The barb outside diameter should match the inner diameter of your flexible hose. For example, if your hose has a 10 mm inner bore, select the variant with a 10 mm barb. A correctly sized barb creates a secure interference fit; an oversized barb can split the hose, and an undersized barb will leak.

Yes, for male BSP threads, wrapping 2–3 layers of PTFE (plumber’s) tape around the thread before assembly is recommended to achieve a leak-free seal. Female BSP threads typically seal against a bonded washer or O-ring on the mating male fitting — check your port design.

Stainless steel offers good resistance to water, mild acids, and many fuels. However, compatibility depends on the specific fluid and concentration. For aggressive chemicals or high-temperature applications, contact us to confirm suitability before ordering.

For low-pressure water or air lines, the barb profile alone often provides adequate retention. For higher-pressure, vibration-prone, or safety-critical applications, fitting a stainless steel hose clamp over the barb is strongly recommended to prevent hose blow-off.