White PVC-U Pipe Adhesive Fittings Sleeve Elbow Tee Union Reducer Cap Water

Select the Sleeve model in the matching pipe size. It provides a double-socket solvent-weld joint that aligns two pipe ends in a straight run. If you need to step between two different diameters, choose the Reducer Sleeve or Concentric Bushing instead.

No. PVC-U is rated for cold and ambient-temperature water service only (typically up to 60 °C maximum, with pressure de-rating above 20 °C). For hot water or steam applications, use CPVC, copper, or stainless steel fittings. Contact us to confirm the exact temperature and pressure rating for the specific size you need.

A correctly made solvent-weld joint chemically fuses the fitting socket and pipe wall into a single monolithic piece. When cured, it typically exceeds the burst pressure of the pipe itself, making it the strongest and most leak-resistant connection method for PVC-U. Allow the manufacturer-recommended cure time (usually 15–30 minutes before handling, 24 hours before pressure testing) before putting the system into service.

Yes. PVC-U is inherently corrosion-proof and resistant to most dilute acids, alkalis, fertiliser solutions, and chlorinated water. It will not rust, scale, or pit. However, it is not compatible with concentrated solvents, aromatic hydrocarbons, or chlorinated solvents — avoid contact with these substances.

Measure the outside diameter (OD) of your existing pipe. PVC-U pipe sizes are designated by OD: 20 mm, 25 mm, 32 mm, 40 mm, 50 mm, 75 mm, 125 mm, 160 mm, and 200 mm. Select the fitting size that matches your pipe OD. For transitions between two different pipe sizes, choose a Reducer Sleeve, Reducer Tee, or Concentric Bushing with the appropriate inlet and outlet dimensions.

Yes — several models are designed specifically for this. The Sleeve × Male Thread and Male Thread Nipple variants provide a BSP male thread on one end for screwing into female-threaded metal valves or fittings. The 90° Elbow × Female Thread accepts a BSP male thread. The Sleeve × Hose Nozzle and Male Thread × Hose Nozzle models terminate in a barbed nozzle for push-on hose connections. Always use PTFE tape on threaded joints.

The Ball Valve Sleeve has solvent-weld sockets on both ends, so it installs directly into a PVC-U pipe run using solvent cement — no threading required. The Female Thread Ball Valve has BSP female threads on both ends, making it suitable for connecting between two male-threaded fittings or metal pipe nipples. Choose based on whether your installation is a solvent-weld or threaded system.

No power tools are required. You will need a pipe cutter or fine-tooth saw to cut the pipe square, fine-grit sandpaper or a deburring tool to chamfer the pipe end, PVC-U solvent cement and primer (sold separately), and a brush or applicator. For threaded variants, a pipe wrench and PTFE tape are also needed. The solvent-weld process itself is tool-free — apply primer, apply cement, push and twist the joint, and hold for 30 seconds.