ABS Plastic Round Hollow Tube 250mm — White Hollow Pipe for DIY Models & Crafts

Match the outer diameter to your design's bore or slot size. As a general rule, select a diameter that fits snugly inside any mating part without forcing. For scale model work, 2–4mm tubes are typically used for fine structural details, while 5–8mm tubes suit larger frames or structural columns. All tubes are 250mm (≈9.8") long and can be cut to any shorter length with a hobby knife or fine-tooth saw.

ABS plastic is generally rated for light-to-moderate structural loads in hobby and craft applications. It is not intended for load-bearing construction or high-pressure applications. For scale models, RC frames, and craft assemblies, the wall thickness is typically sufficient to resist bending and compression under normal handling. Contact us to confirm suitability for specific load requirements.

ABS plastic has moderate UV resistance and can generally withstand short-term outdoor exposure. For prolonged outdoor use, applying a UV-protective clear coat is recommended to prevent yellowing or surface degradation. These tubes are not rated for continuous immersion in water or harsh chemical environments.

Yes. These tubes are made from standard ABS plastic and bond reliably with ABS plastic cement (solvent-based), cyanoacrylate (super glue), and most two-part epoxy adhesives. Solvent cement creates a molecular bond for the strongest joints. Lightly sanding the bonding surface improves adhesion with any adhesive type.

If you are prototyping or testing a design, starting with 1–2 pieces lets you confirm fit before committing. For ongoing model builds, RC projects, or classroom/workshop use, packs of 10–100 pieces offer a lower per-unit cost and ensure you have spares on hand. Bulk packs of 200–500 are suited for production runs or resale.

Yes. ABS plastic accepts most hobby paints, including acrylic, enamel, and lacquer. For best results, lightly sand the surface with fine-grit sandpaper (typically 400–600 grit) and apply a plastic-compatible primer before painting. Spray paint adheres more evenly than brush-applied paint on smooth ABS surfaces.

A sharp hobby knife (X-Acto style), a fine-tooth razor saw, or a rotary tool with a cutting disc all work well for cutting ABS tubes. Score-and-snap works for smaller diameters (2–4mm). For clean, square cuts on larger diameters (5–8mm), a miter box with a fine-tooth saw is recommended. Deburr cut edges with fine sandpaper for a clean finish.