Clear Flexible Braided PVC Hose — Food Grade, ID 8mm–50mm, Oil Water Tube

Match the hose ID (inner diameter) to the OD of your barb fitting or pipe stub. For example, a 16mm ID hose fits a 16mm male barb fitting. For wall thickness: 2mm is generally suitable for light-duty, low-pressure gravity-feed runs; 3–4mm covers most general workshop, brewing, and food-processing pump applications; 4.5–5mm provides additional durability for higher-pressure or more demanding setups. For inch-to-metric reference: 8mm ≈ 5/16", 10mm ≈ 3/8", 12mm ≈ 1/2", 16mm ≈ 5/8", 19mm ≈ 3/4", 25mm ≈ 1", 32mm ≈ 1-1/4", 38mm ≈ 1-1/2", 50mm ≈ 2".

Braided clear PVC hose is generally rated for working pressures in the range of 40–120 PSI, depending on the inner diameter and wall thickness selected. Thicker walls and smaller diameters typically support higher pressures. For safety-critical or regulated applications, contact us to confirm the rated working pressure for your specific ID and wall thickness combination before ordering.

This hose is made from a food-grade PVC compound that is generally suitable for use with potable water, beverages, and food-processing fluids. It does not impart taste or odor to the fluid under normal operating conditions. For regulated food-production or commercial brewing environments, verify compliance with your applicable local food-safety standards (such as FDA 21 CFR or NSF/ANSI 51) before installation.

Yes. The flexible PVC wall is designed to stretch slightly over standard barbed fittings — simply match the barb OD to the hose ID. Secure with a worm-drive hose clamp or a crimp ring for a leak-free connection. Both metric and inch-equivalent barb fittings are generally compatible. No adhesive or thread sealant is needed at the barb joint.

This hose is generally suitable for light oil transfer applications such as lubricating oils, hydraulic return lines at low pressure, and similar non-aromatic petroleum products. It is not typically recommended for concentrated fuels, aromatic solvents, or high-pressure hydraulic systems. Always verify chemical compatibility with your specific fluid before installation. Contact us if you need confirmation for a specific application.

Standard clear PVC is not UV-stabilized and will typically become brittle or discolor with prolonged direct sunlight exposure. For outdoor installations, it is generally recommended to route the hose through conduit, wrap it with UV-protective tape, or run it through a shaded channel. For permanently exposed outdoor runs, contact us for guidance on UV-resistant alternatives.

Food-grade clear braided PVC hose is generally rated for use in temperatures ranging from approximately 32°F to 140°F (0°C to 60°C). Avoid use in steam lines, hot water systems above this range, or applications where the hose contacts surfaces that exceed 140°F. For higher-temperature requirements, contact us to discuss alternative hose materials.

Use a sharp utility knife or a dedicated PVC tube cutter for a clean, square cut. Score around the circumference first, then cut through in one firm motion. Avoid sawing back and forth, which can fray the braid reinforcement layer and leave a rough edge that prevents a proper seal against the fitting. A clean square cut is essential for a leak-free clamp connection.