Heavy Duty Toggle Switch On-Off / On-Off-On — SPST/SPDT 2/3 Position, 2/4/6 Pin, 5A 250VAC

Match the pin count to your circuit type: 2-pin (SPST) for simple on/off circuits, 4-pin (DPST) for dual-circuit control, and 6-pin (SPDT or DPDT) for on-off-on or changeover applications. For panel cutout, these switches typically require a 12mm (≈15/32″) mounting hole. As a reference, 12mm ≈ 0.47 inches. Always verify your panel thickness and bushing clearance before ordering.

These switches are rated at 5A 250VAC. For DC applications, the rating is generally lower — typically around 5A 28VDC, though this can vary by model. DC arcing is harder to extinguish than AC, so always derate appropriately for inductive DC loads (motors, solenoids). Contact us to confirm the DC rating for a specific variant.

The standard E-TEN models are not rated for direct outdoor or wet exposure. However, the 12mm Waterproof Cap accessory (available as a separate variant on this listing) can be fitted over the toggle lever to provide splash resistance for light-duty outdoor or marine use. For fully weatherproof installations, additional panel sealing is recommended.

A 2-position switch (On-Off) has two stable states: fully on or fully off. A 3-position switch (On-Off-On) has three states: on in one direction, off in the center, and on in the other direction — useful for reversing motors, selecting between two circuits, or controlling dual loads. Momentary variants (E-TEN123, E-TEN223) return to center when released rather than staying latched.

Yes. The E-TEN series generally fits a standard 12mm (≈15/32″) round panel cutout, which is the most common size for miniature toggle switches in the US. The threaded bushing and hex nut secure the switch to panels typically up to 3–5mm thick. Contact us to confirm exact bushing thread specs for your application.

The Black Gumwood variants feature a black rubber-like toggle lever instead of the standard metal or plastic lever. This provides a more tactile grip and a distinctive blacked-out appearance, making them popular in automotive, marine, and custom panel builds. Electrically, they perform identically to the standard finish variants.

Momentary toggle switches only maintain contact while the lever is held in position. When released, the lever springs back to its default (center or off) position. These are typically used for horn buttons, starter circuits, jog controls, or any application where a brief pulse of current is needed rather than a sustained connection.

A 6-pin DPDT on-off-on switch has two independent poles, each with a common, a normally-open, and a normally-closed terminal. In most configurations: connect your power source to the two center (common) terminals, your first load to the top pair, and your second load to the bottom pair. Flipping the lever routes power to one load or the other, with the center position disconnecting both. Always refer to the specific wiring diagram for your model — contact us if you need a terminal diagram.