M1.2–M2.6 Pan Head Self-Tapping Screws A2 304 Stainless Steel, Phillips Drive

Yes. The M1.2, M1.4, and M1.7 sizes are specifically suited for eyeglass hinges, watch bands, and small electronic enclosures. The 304 stainless steel construction resists rust from skin contact, sweat, and ambient humidity — common failure points for standard plated screws.

In thin plastics, soft metals, and most electronics housings, these screws will self-tap directly without a pilot hole. For harder materials or very precise applications, a pilot hole approximately 80% of the thread diameter ensures the cleanest result and prevents galling on the tiny threads.

All listed lengths are the thread length only — measured from directly under the pan head to the tip. This makes it straightforward to match the screw to your exact material thickness without guessing.

M1.2–M1.4 typically require a #000 or #00 Phillips precision screwdriver. M1.7–M2 generally use #0, and M2.2–M2.6 use #0 or #1. A quality precision screwdriver set covering #000 through #1 will handle all sizes and minimize cam-out risk.

These screws are designed for thin sheet metal, ABS and PC plastics, wood composites, and electronics housings. They are not intended for structural steel, concrete, or masonry applications. For best results in harder materials, use a pilot hole and apply light, steady pressure during installation.

A2 / 304 stainless steel is generally considered non-magnetic in its annealed state, though it may exhibit slight magnetic response after cold working (such as thread rolling). For sensitive electronics or magnetic-critical applications, this is typically not an issue at these micro sizes.

Self-tapping screws can generally be reinstalled into the same hole they originally tapped, as long as the threads in the base material are not damaged. Avoid over-torquing during initial installation to preserve the tapped threads for future reuse.