4ft Metal Pegboard Wall Organizer Kit, 48"x24" Garage Tool Storage with Drill Bit Rack, Wrench Rack & Hooks, Black

The assembled pegboard panel measures 48" wide (4 ft) x 24" tall x 1" deep. You will need a clear wall section of at least 48 inches wide and 24 inches tall. Allow a few extra inches on each side for the mounting hardware and for comfortable hook access at the edges of the panel.

The total weight capacity of this pegboard system is rated at up to 132 lbs when properly mounted to a solid wall surface. Distribute weight evenly across the panel rather than concentrating heavy tools on a single hook or a small area of the board. For very heavy items like large pipe wrenches or power tool bodies, use the shelf tiers of a separate storage unit instead.

Yes. The kit includes six expansion bolts specifically designed for mounting on concrete and masonry walls — a common garage wall type that most pegboard kits don’t address. Standard screws and nuts are also included for wood stud or drywall installations. Pre-drilled holes on the back of the panels simplify alignment during installation.

The kit includes: 3 metal pegboard panels, 8 pegboard hooks in two different lengths, 4 double-slant holders (for hammers and pliers), 2 eight-slot wrench racks, 1 drill bit rack, 1 screwdriver holder, and all mounting hardware (expansion bolts, screws, and nuts). Detailed installation instructions are also included in the box.

The included hooks and accessories are designed to fit the hole pattern on these specific panels. Standard 1/4" pegboard hooks from other brands are generally compatible with this panel’s hole spacing, but we recommend verifying hook peg diameter before mixing accessories from different manufacturers to ensure a secure fit.

The panels are constructed from cold-rolled steel with a rust-resistant powder-coated finish, making them well-suited for covered garages, workshops, and warehouses. They are generally not recommended for fully exposed outdoor environments with direct rain or standing moisture. For humid garages, ensure adequate ventilation to minimize condensation on the panel surface.

Installation typically takes 20–40 minutes. You will generally need a drill (with a masonry bit for concrete walls), a level, and a screwdriver or wrench. All mounting hardware is included in the box. Pre-drilled holes on the back of the panels make alignment straightforward, and detailed instructions walk you through each step.