Metal Toggle Switch 250VAC 15A — SPST / SPDT / DPST / DPDT Panel Mount Flick Switch

SPST (Single Pole Single Throw) controls one circuit with simple on/off. SPDT (Single Pole Double Throw) routes one circuit to one of two outputs — useful for selector switches. DPST doubles the poles of SPST, switching two circuits simultaneously with one lever. DPDT doubles the poles of SPDT, giving you two circuits each routable to two outputs — the go-to choice for motor reversing applications. For a simple light or fan, SPST is typically all you need. For reversing a DC motor or switching between two power sources, a DPDT toggle switch is generally the right call.

Latching (maintained) switches stay in position after you flip them — the circuit remains open or closed until you flip again. Momentary switches spring back to their default position as soon as you release the lever. In most cases, latching is used for permanent on/off control (equipment power, lighting), while momentary is used for push-to-activate functions like horns, engine starters, or signal triggers.

These switches are rated 250VAC 15A, which is generally sufficient for most household lighting circuits, small motors, and control panel loads at both 120V (US) and 230V (EU). DC ratings are typically lower than AC ratings for the same switch — if your application is DC, contact us to confirm the appropriate rating for your specific model before installation.

The switches themselves are not rated for direct outdoor exposure. However, the optional Waterproof Cover accessory (available as a variant on this listing) provides a protective rubber boot over the toggle lever, making them suitable for semi-protected outdoor enclosures, marine dashboards, and dusty workshop environments. For fully submersed or high-pressure wash-down applications, a fully sealed IP-rated switch would generally be more appropriate.

E-TEN series models use screw terminals — you insert the wire and tighten a screw to clamp it in place. This is ideal for panel wiring where a secure, vibration-resistant connection is needed. BEM series models use pin (solder or quick-connect) terminals, which are generally preferred for PCB mounting or pre-made wire harness connections. Both series cover the same SPST/SPDT/DPST/DPDT configurations and 250VAC 15A rating.

Standard toggle switches in this class typically require a panel cutout of approximately 12mm (≈15/32"). Always verify the specific model's datasheet for exact mounting hole dimensions before drilling, as minor variations can exist between E-TEN and BEM series models. The switch body is secured to the panel with a threaded bushing and nut in most cases.

Yes. The 250VAC rating covers both US 120V and EU 230V mains voltages. Screw-terminal E-TEN models typically accept wire gauges in the AWG 14–18 range. Always follow local electrical codes and use appropriately rated wire and enclosures for your specific application.