DIY TIPS

How to Make a Simple Hand Saw Handle with a Bolt

If you have a spare saw blade but no handle, don't throw it away. This guide shows you how to turn a basic bolt, two nuts, and a bit of tubing into a sturdy, custom grip. It’s a practical, no-nonsense way to build a functional tool from scratch.

How to Make a Simple Hand Saw Handle with a Bolt - HomeDIYer

Materials List

  • Hacksaw blade
  • Long threaded bolt
  • Two matching nuts
  • Rubber or plastic tubing

Step by Step

Step 1: Prep the Bolt

Use an angle grinder to cut a vertical slot into the top of the bolt.

Step 2: Install the Blade

Thread two nuts onto the bolt and insert the blade into the slot.

Step 3: Secure the Mechanism

Tighten the nuts upward to lock the blade firmly in place.

Step 4: Add the Handle Grip

Slide the tubing over the bolt to create a comfortable grip.

 

This hack is a lifesaver for quick fixes or tight spots where a full-sized saw won't fit. It’s a simple, reliable way to get the job done when you’re missing the right handle.

Recommended Products
← Previous article
The Invisible Joint: How to Connect Wood Seamlessly with a Single Screw
The Invisible Joint: How to Connect Wood Seamlessly with a Single Screw - HomeDIYer
Next article →
Wire Fixing Tip – DIY Cable Clamp with Heat Shrink Tubing
Wire Fixing Tip – DIY Cable Clamp with Heat Shrink Tubing - HomeDIYer

Comments

No comments yet
No comments yet

Leave a comment

Please note that comments need to be approved before they are published.